Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure: Procedure
- CHECK POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (WINDOW LOCK SWITCH)
- Turn the window lock switch off and operate the switches on the master switch. Check that the remote up/down function operates normally.
OK
Remote up/down function operates normally.
NG → See step 2
OK → END
- Turn the window lock switch off and operate the switches on the master switch. Check that the remote up/down function operates normally.
- CHECK MANUAL UP/DOWN FUNCTION
- Check that the passenger side door power window manual up/down function operates normally.
OK
Manual up/down function operates normally.
NG → See step 3
OK → See step 5
- Check that the passenger side door power window manual up/down function operates normally.
- CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY - POWER WINDOW REGULATOR SWITCH ASSEMBLY)
- Disconnect the E1 power window regulator master switch assembly connector.
- Disconnect the D1 power window regulator switch assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition E1-18 (D) - D1-2 (SD) Always Below 1 Ω E1-16 (U) - D1-5 (SU) Always Below 1 Ω E1-18 (D) or D1-2 (SD) - Body ground Always 10 kΩ or higher E1-16 (U) or D1-5 (SU) - Body ground Always 10 kΩ or higher
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK → See step 4
- REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY. Refer to REMOVAL
- REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY. Refer to REMOVAL
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
