2012 Scion tC Automatic TransFACTORY OEM SERVICE PROCEDURE

Valve Body Assembly: Installation: Installation

  1. INSTALL MANUAL VALVE 
    1. Coat the manual valve with ATF and install it to the transmission valve body assembly.
  2. INSTALL NO. 1 GOVERNOR APPLY GASKET 
    1. Coat 2 new No. 1 governor apply gaskets with ATF.
    2. Install the 2 No. 1 governor apply gaskets onto the transaxle case.
  3. INSTALL TRANSMISSION VALVE BODY ASSEMBLY 
    1. Coat the O-ring of the transmission wire with ATF.
    2. Confirm that the manual valve lever is positioned as shown in the illustration and install the transmission valve body assembly to the transaxle case with the 11 bolts.
      Fig 1: Transmission Valve Body Assembly Bolts
      GTY313631Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *a Positioning Bolt

      Bolt A, B, C 

      Torque: 11 N*m (110 kgf*cm, 8 ft.*lbf) 

      Bolt D 

      Torque: 9.6 N*m (98 kgf*cm, 85 in.*lbf) 

      Bolt length

      Bolt A 

      25 mm (0.984 in.)

      Bolt B 

      30 mm (1.18 in.)

      Bolt C, D 

      35 mm (1.38 in.)

      NOTE:
      • When installing the transmission valve body assembly, be careful not to allow the speed sensor and transaxle case to interfere with each other.
      • Be sure to insert the pin of the manual valve lever into the groove on the end of the manual valve.
      • First, temporarily install the bolts marked *a in the illustration because they are positioning bolts.
  4. INSTALL VALVE BODY OIL STRAINER ASSEMBLY  See step  54
  5. INSTALL TRANSMISSION OIL CLEANER MAGNET  See step  55
  6. INSTALL AUTOMATIC TRANSAXLE OIL PAN GASKET  See step  56
  7. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY  See step  57
  8. ADJUST AUTOMATIC TRANSAXLE FLUID 

    Refer to ADJUSTMENT 

  9. INSTALL NO. 1 ENGINE UNDER COVER  . Refer to INSTALLATION - Step 83
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.