Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2012 Scion iQFACTORY OEM SERVICE PROCEDURE

Camshaft Position Sensor: Removal: Removal

REMOVE CAMSHAFT POSITION SENSOR
1. for Exhaust Side:
  1. Disconnect the connector of the camshaft position sensor.
    
    Fig 1: Identifying Camshaft Position Sensor Connector (For Exhaust Side)
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.
    
    Fig 2: Identifying Camshaft Position Sensor Bolt (For Exhaust Side)
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Chapter Navigation

Return to Chapter: Removal

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.