2012 Scion iQFACTORY OEM SERVICE PROCEDURE

Front Speed Sensor: Removal: Removal

  1. REMOVE FRONT WHEEL 
  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD  . Refer to REMOVAL - Step 1
  3. REMOVE FENDER REAR PLATE MUDGUARD  . Refer to REMOVAL - Step 1
  4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY  . Refer to REMOVAL - Step 4
  5. SEPARATE WIRE HARNESS (for RH Side) 
    1. Disengage the clamp from the No. 3 sensor clamp.
      Fig 1: Identifying No. 3 Sensor Clamp
      GTY345618Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE FRONT SPEED SENSOR 
    1. Disconnect the front speed sensor connector.
      Fig 2: Identifying Front Speed Sensor Clamps And Bolts
      GTY347357Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *1 No. 1 Sensor Clamp *2 No. 2 Sensor Clamp
      *3 No. 3 Sensor Clamp *4 Bolt A
      *5 Bolt B *6 Bolt C
      *7 Nut *8 Speed Sensor Connector
    2. Remove the nut and the No. 3 sensor clamp from the body.
    3. Remove the bolt C and separate the No. 2 sensor clamp from the shock absorber.
    4. Remove the bolt B and separate the brake flexible hose and No. 1 sensor clamp from the shock absorber.
    5. Remove the bolt A and the front speed sensor from the steering knuckle.
      NOTE:
      • Prevent foreign matter from attaching to the sensor tip.
      • Clean the installation hole and the surface for the front speed sensor every time the front speed sensor is removed.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.