2011 Scion xD AutomaticFACTORY OEM SERVICE PROCEDURE

Speed Sensor: Removal: Removal

  1. REMOVE BATTERY  . Refer to REMOVAL - Step 2
  2. REMOVE BATTERY TRAY 
  3. REMOVE BATTERY CARRIER  . Refer to REMOVAL - Step 21
  4. REMOVE SPEED SENSOR NT 
    1. Disconnect the speed sensor NT connector.
      Fig 1: Identifying Bolt And Transmission Revolution Sensor
      GTY166060Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and speed sensor NT.
    3. Remove the O-ring from the speed sensor NT.
      Fig 2: Identifying O-Ring And Transmission Revolution Sensor
      GTY166263Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.