2011 Scion xD AutomaticFACTORY OEM SERVICE PROCEDURE

How To Proceed With Troubleshooting

HINT: 

  • Use these procedures to troubleshoot the power window control system.
  • *: Use a Techstream.
  1. VEHICLE BROUGHT TO WORKSHOP 

    NEXT: Refer to next step 

  2. INSPECT BATTERY VOLTAGE 

    Standard voltage

    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT: Refer to next step 

  3. PROBLEM SYMPTOMS TABLE 
    RESULT

    Result Refer to
    Fault is not listed in problem symptoms table A
    Fault is listed in problem symptoms table B

    B → refer to step 5 

    A: Refer to next step 

  4. OVERALL ANALYSIS AND TROUBLESHOOTING* 
    1. Terminals of ECU. Refer to TERMINALS OF ECU 
    2. Operation check. Refer to OPERATION CHECK 
    3. DATA LIST / ACTIVE TEST. Refer to DATA LIST / ACTIVE TEST 

      NEXT: Refer to next step 

  5. REPAIR OR REPLACE 

    NEXT: Refer to next step 

  6. CONFIRMATION TEST 

    NEXT → END 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.