Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Scion xB StandardFACTORY OEM SERVICE PROCEDURE
Service Data
| Battery | Standard specific gravity: | 1.25 to 1.29 at 20°C (68°F) |
| Standard voltage | 12.5 to 12.9 V at 20°C (68°F) | |
| Charging circuit without load | Standard current | 10 A or less |
| Standard voltage | 13.2 to 14.8 V | |
| Charging circuit with load | Standard current | 30 A or more |
| Generator brush holder assembly brush length | Standard length | 9.5 to 11.5 mm (0.374 to 0.453 in.) |
| Minimum length | 4.5mm (0.177 in.) | |
| Generator rotor assembly resistance | Slip rings | 2.3 to 2.7 Ω at 20°C (68°F) |
| Slip ring - Rotor | 1 MΩ or higher | |
| Generator rotor assembly slip ring diameter | Standard diameter | 14.2 to 14.4 mm (0.560 to 0.566 in.) |
| Minimum diameter | 14 mm (0.552 in.) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.