2011 Scion xB AutomaticFACTORY OEM SERVICE PROCEDURE

Shift Lever: Installation: Installation

  1. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY 
    1. Install the shift lever knob sub-assembly onto the shift lever assembly.
      Fig 1: Identifying Shift Lever Knob Sub-Assembly
      GTY158289Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL SHIFT LEVER ASSEMBLY 
    1. Install the shift lever assembly with the 4 nuts.
      Fig 2: Locating Shift Lever Assembly Nuts
      GTY165176Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf) 

  3. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Rotate the transmission control cable nut counterclockwise approximately 180° and, while holding the nut in that position, press in the stopper until it makes 2 "click" sounds.
      Fig 3: Installing Transmission Control Cable Assembly Components
      GTY158678Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Push the lock piece up from the back side of the adjuster case while pinching the claws on the lock piece.
      Fig 4: Transmission Control Cable Lock Piece Location
      GTY162138Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the cable outer of the transmission control cable onto the shift lever retainer, check that the position of the spring is the same as A shown in the illustration, and press in the stopper.
      Fig 5: Installing Transmission Control Cable Components
      GTY158092Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      If the stopper cannot be pressed in, slightly rotate the nut clockwise and then press in the stopper.

    4. Connect the control cable to the shift lever.
      Fig 6: Identifying Transmission Control Cable Assembly Lock Piece
      GTY166844Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.