Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Scion tC AutomaticFACTORY OEM SERVICE PROCEDURE
Service Data
| Starter assembly | No-load characteristics current | 90 A or less at 11.5 V | |
| Starter armature assembly | Standard commutator length | 3.1 mm (0.122 in.) | |
| Maximum commutator length | 3.8 mm (0.150 in.) | ||
| Commutator end frame assembly Brush |
Standard length | 9.0 mm (0.354 in.) | |
| Maximum length | 4.0 mm (0.157 in.) | ||
| Snap ring | Maximum length | 5.0 mm (0.197 in.) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.