2011 Scion tC AutomaticFACTORY OEM SERVICE PROCEDURE

Automatic Transaxle (Service Information): TCM: Installation: Installation

  1. INSTALL TCM 
    1. Install the TCM to the automatic transaxle.
      Fig 1: TCM Bolts Tightening Sequence
      GTY298690Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install and tighten the 2 bolts in the order shown in the illustration.

      Torque: 11 N*m (115 kgf*cm, 8 ft.*lbf) 

    3. Connect the connector.
      Fig 2: Connecting TCM Connector
      GTY312536Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *1 Lock Lever
    4. Turn the lock lever and attach the claw to secure the connector.
  2. INSTALL BATTERY CARRIER ASSEMBLY  . Refer to INSTALLATION - Step 2
  3. INSTALL BATTERY TRAY 
  4. INSTALL BATTERY 
  5. INSTALL BATTERY INSULATOR 
  6. INSTALL BATTERY CLAMP SUB-ASSEMBLY  . Refer to INSTALLATION - Step 6
  7. INSTALL AIR CLEANER CASE SUB-ASSEMBLY  . Refer to INSTALLATION - Step 3
  8. INSTALL AIR CLEANER CAP SUB-ASSEMBLY  . Refer to INSTALLATION - Step 4
  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

  10. CHECK AUTOMATIC TRANSAXLE SYSTEM 
    NOTE:

    If automatic transaxle parts are replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary. Refer to PRECAUTION .

Chapter Navigation
Return to Chapter: Installation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.