Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Scion tC AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
BRAKE ACTUATOR
| Part Tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Brake tube x Brake actuator assembly | 15 | 155 | 11 |
| Brake actuator bracket x Brake actuator assembly | 5.4 | 55 | 48 in.*lbf |
| Brake actuator with bracket x Body | 19 | 194 | 14 |
FRONT SPEED SENSOR
| Part Tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Front speed sensor bolt | 8.5 | 87 | 75 in.*lbf |
| No. 1 sensor clamp x Front shock absorber | 19 | 192 | 14 |
| No. 2 sensor clamp x Body | 8.5 | 87 | 75 in.*lbf |
REAR SPEED SENSOR
| Part Tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Skid control sensor wire clamp bolt | 8.0 | 82 | 71 in.*lbf |
YAW RATE AND ACCELERATION SENSOR
| Part Tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Yaw rate and acceleration sensor bolt | 8.5 | 87 | 75 in.*lbf |
| No. 4 crossmember floor reinforcement bolt | 27 | 275 | 20 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.