2009 Scion tC StandardFACTORY OEM SERVICE PROCEDURE

Camshaft Timing Oil Control Valve Assembly: Inspection

  1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY 
    1. Measure the resistance of the oil control valve.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Specified Condition
      1 (+B) - 2 (GND) 6.9 to 7.9 Ω at 20°C (68°F)

      If the result is not as specified, replace the oil control valve assembly.

      Fig 1: Inspecting Camshaft Timing Oil Control Valve Assembly
      G05183802Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Check the operation.
      1. Apply battery voltage across the terminals and check that the spool valve operates.
        NOTE: Check that the spool valve is not stuck.

        HINT:

        The spool valve may not return if foreign objects are caught in it. This may cause subtle pressure leaks to the advance side, and a DTC may be set.

        Fig 2: Inspecting Camshaft Timing Oil Control Valve Assembly
        G06276476Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.