2009 Scion tC StandardFACTORY OEM SERVICE PROCEDURE

Inspection Procedure

  1. CHECK MANUAL UP/DOWN FUNCTION (DRIVER SIDE) 
    1. Check that the power window manual UP/DOWN function operates normally.

    NG: OTHER PROBLEM 

    OK: Go to next step 

  2. CHECK LIGHT OF POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (DRIVER SIDE SWITCH) 
    1. Turn the ignition switch ON.
    2. Operate the driver side switch on the master switch.
    3. Check the blinking pattern of the AUTO light as shown in the illustration.

      Result 

      RESULT CHART

      Result Proceed to
      Pattern (1) or (3) is displayed A
      Pattern (2) is displayed B
      Normal pattern is displayed C
      Fig 1: Identifying Power Window Regulator Master Switch
      G05541743Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.