Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Windshield Glass: Installation
- INSTALL NO. 2 WINDSHIELD GLASS STOPPER
- Apply Primer G to the installation part of the stoppers.
HINT:
If primer G is applied to an area other than that which is specified, wipe off the primer with white gasoline before it dries.
NOTE:- Allow the primer to dry for 3 minutes or more.
- Throw away any leftover primer.
- Do not apply too much primer.
- Install 2 new stoppers onto the windshield glass as shown in the illustration.
Standard measurement
MEASUREMENT REFERENCEArea Measurement a 7.7 mm (0.303 in.) b 7.7 mm (0.303 in.) c 12.5 mm (0.492 in.)
- Apply Primer G to the installation part of the stoppers.
- INSTALL NO. 1 WINDSHIELD GLASS STOPPER
- Install 2 new stoppers to the vehicle body as shown in the illustration.
- INSTALL WINDSHIELD GLASS ADHESIVE DAM
- Apply Primer G to the glass where the glass adhesive dams will be installed.
HINT:
If primer G is applied to an area other than that which is specified, wipe off the primer with white gasoline before it dries.
- Apply Primer G to the glass where the glass adhesive dams will be installed.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.