Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
- CHECK MILÂ
- Check that MIL (Malfunction Indicator Lamp) lights up when turning the ignition switch to the ON position.
Standard:Â
MIL lights upÂ
OK: SYSTEM OKÂ
NG: Go to Next StepÂ
- Check that MIL (Malfunction Indicator Lamp) lights up when turning the ignition switch to the ON position.
- CHECK CONNECTION BETWEEN TECHSTREAM AND ECMÂ
- Connect the Techstream to the DLC3.
- Turn the ignition switch to the ON position and turn the Techstream on.
- Check the communication between the Techstream and ECM.
ResultÂ
RESULT CHARTCondition Proceed to Communication is possible A Communication is not possible B
A: GO TO MIL CIRCUIT (See  MIL CIRCUIT  ))Â
B: Go to Next StepÂ
- INSPECT ECM (VC VOLTAGE)Â
- CHECK MIL (THROTTLE POSITION SENSOR)Â
- Disconnect the T1 throttle body connector.
- Turn the ignition switch to the ON position.
- Check the MIL.
ResultÂ
RESULT CHARTCondition Proceed to MIL illuminates A MIL does not illuminate B - Reconnect the throttle body connector.
A: REPLACE THROTTLE BODYÂ (See ON-VEHICLE INSPECTIONÂ )
B: Go to Next StepÂ
- CHECK MIL (CANISTER PUMP MODULE)Â
- Disconnect the T1 throttle body connector.
- Turn the ignition switch to the ON position.
- Check the MIL
ResultÂ
RESULT CHARTCondition Proceed to MIL illuminates A MIL does not illuminate B - Reconnect the throttle body connector.
A: REPLACE CANISTERÂ (See REMOVAL )
B: Go to Next StepÂ
- CHECK WIRE HARNESS (ECM - BODY GROUND)Â
- Disconnect the T1 throttle body connector.
- Disconnect the L1 canister pump module connector.
- Disconnect the E8 ECM connector.
- Measure the resistance according to the value (s) in the table below.
Standard resistanceÂ
TESTER CONNECTION SPECIFIED CONDITION CHARTTester Connection Specified Condition E8-18 (VC) - Body ground 10 kΩ or higher - Reconnect the throttle body connector.
- Reconnect the canister pump module connector.
- Reconnect the ECM connector.
NG: REPAIR OR REPLACE HARNESS OR CONNECTORÂ
OK: REPLACE ECMÂ (See REMOVALÂ )
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
