2008 Scion xD StandardFACTORY OEM SERVICE PROCEDURE

Camshaft Timing Oil Control Valve Assembly: Removal

  1. REMOVE NO. 2 CYLINDER HEAD COVER  (See REMOVAL )
  2. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY 
    1. Remove the bolt and the wire harness bracket.
      Fig 1: Locating Wire Harness Bracket Bolt
      G05398713Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the camshaft timing oil control valve assembly connector (for exhaust camshaft side).
    3. Fig 2: Locating Camshaft Timing Oil Control Valve Connector Bolt (For Exhaust Camshaft Side)
      G05398714Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the bolt and remove the camshaft timing oil control valve assembly (for exhaust camshaft side).
    5. Remove the O-ring from the camshaft timing oil control valve assembly (for exhaust camshaft side).
      Fig 3: Locating Camshaft Timing Oil Control Valve O-Ring (For Exhaust Camshaft Side)
      G05398715Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Disconnect the camshaft timing oil control valve assembly connector (for intake camshaft side).
    7. Remove the bolt and remove the camshaft timing oil control valve assembly (for intake camshaft side).
      Fig 4: Locating Camshaft Timing Oil Control Valve Bolt (For Intake Camshaft Side)
      G05398716Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    8. Remove the O-ring from the camshaft timing oil control valve assembly (for intake camshaft side).
      Fig 5: Locating Camshaft Timing Oil Control Valve O-Ring (For Intake Camshaft Side)
      G05398717Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.