Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2008 Scion xD AutomaticFACTORY OEM SERVICE PROCEDURE

Accelerator Pedal Rod: Installation

NOTE:

Avoid any physical shock to the accelerator pedal.

INSTALL ACCELERATOR PEDAL ASSEMBLY
1. Install the accelerator pedal with the 2 bolts.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
2. Connect the accelerator pedal connector.
  
  Fig 1: Locating Accelerator Pedal Bolts And Accelerator Pedal Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.