Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
2008 Scion xD AutomaticSECTION Inspection Procedure
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0111)
- Connect a Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the tester ON.
- Select the following menu items: Powertrain / Engine and ECT / Trouble Codes.
- Read DTCs.
Result
RESULT REFERENCEResult Proceed to P0111 and other DTCs A P0111 B HINT:
If any DTCs other than P0111 are output, troubleshoot those DTCs first.
B : REPLACE MASS AIR FLOW METER (See REMOVAL )
A: Go to DTC CHART (See DIAGNOSTIC TROUBLE CODE CHART )
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.