Name: AllOEMManuals
Address: 316 Brandywine Ave, Streetman, TX, 75859, US
Telephone: +14699867883
Price range: $$

INSTALL HEATED OXYGEN SENSOR
1. Using SST, install the heated oxygen sensor onto the front exhaust pipe.
  SST 09224-00010
  
  Torque: without SST
  
  44 N*m (449 kgf*cm, 33 ft.*lbf)
  
  with SST
  
  40 N*m (408 kgf*cm, 30 ft.*lbf)
  NOTE:
  - This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.81 in.) and SST of 30 mm (1.18 in.) (See REPAIR INSTRUCTION ).
  - This torque value is effective when SST is parallel to the torque wrench.
    
    Fig 1: Installing Heated Oxygen Sensor
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Pass the sensor connector through the floor panel and install the grommet.
3. Install the wire harness clamp bracket.
  
  Fig 2: Locating Wire Harness Clamp Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the heated oxygen sensor connector.
INSPECT FOR EXHAUST GAS LEAK
INSTALL FRONT CONSOLE BOX (See INSTALLATION )
INSTALL REAR CONSOLE BOX SUB - ASSEMBLY (See INSTALLATION )
INSTALL CONSOLE BOX CARPET (See INSTALLATION )
INSTALL REAR CONSOLE BOX COVER (See INSTALLATION )
INSTALL UPPER CONSOLE PANEL (See INSTALLATION )
INSTALL SHIFT LEVER KNOB SUB - ASSEMBLY (for Manual Transaxle) (See INSTALLATION )

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Heated Oxygen Sensor: Installation