2008 Scion xD AutomaticFACTORY OEM SERVICE PROCEDURE

Heated Oxygen Sensor: Installation

  1. INSTALL HEATED OXYGEN SENSOR 
    1. Using SST, install the heated oxygen sensor onto the front exhaust pipe.

      SST 09224-00010 

      Torque: without SST 

      44 N*m (449 kgf*cm, 33 ft.*lbf) 

      with SST 

      40 N*m (408 kgf*cm, 30 ft.*lbf) 

      NOTE:
      • This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.81 in.) and SST of 30 mm (1.18 in.) (See REPAIR INSTRUCTION ).
      • This torque value is effective when SST is parallel to the torque wrench.
        Fig 1: Installing Heated Oxygen Sensor
        G05398811Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Pass the sensor connector through the floor panel and install the grommet.
    3. Install the wire harness clamp bracket.
      Fig 2: Locating Wire Harness Clamp Bracket
      G05398808Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Connect the heated oxygen sensor connector.
      5. Fig 3: Locating Heated Oxygen Sensor Connector
      G05398807Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSPECT FOR EXHAUST GAS LEAK 
  3. INSTALL FRONT CONSOLE BOX  (See INSTALLATION )
  4. INSTALL REAR CONSOLE BOX SUB - ASSEMBLY  (See INSTALLATION )
  5. INSTALL CONSOLE BOX CARPET  (See INSTALLATION )
  6. INSTALL REAR CONSOLE BOX COVER  (See INSTALLATION )
  7. INSTALL UPPER CONSOLE PANEL  (See INSTALLATION )
  8. INSTALL SHIFT LEVER KNOB SUB - ASSEMBLY (for Manual Transaxle)  (See INSTALLATION )
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.