2008 Scion xD AutomaticFACTORY OEM SERVICE PROCEDURE

2ZR-FE Engine Control System: ECM: Installation

  1. INSTALL NO. 2 ECM BRACKET 
    1. Install the No. 2 ECM bracket with the 2 screws.
      Fig 1: Locating No 2 ECM Bracket Screws
      G04828454Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL ECM BRACKET 
    1. Install the ECM bracket with the 2 screws.
      Fig 2: Locating ECM Bracket Screws
      G04828455Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL ECM 
    1. Install the ECM with the bolt and 2 nuts.

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

      Fig 3: Locating ECM Bolt And Nuts
      G05398745Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the 2 ECM connectors.
      3. Fig 4: Connecting ECM Connectors
      G05398751Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the 2 lock knobs and harness clamp.
  4. INSTALL OUTER COWL TOP PANEL  (See INSTALLATION )
  5. INSTALL FRONT AIR SHUTTER SEAL RH  (See INSTALLATION )
  6. INSTALL FRONT WIPER MOTOR AND LINK  (See INSTALLATION )
  7. INSTALL COWL TOP VENTILATOR LOUVER LH  (See INSTALLATION )
  8. INSTALL COWL TOP VENTILATOR LOUVER RH  (See INSTALLATION )
  9. INSTALL HOOD TO COWL TOP SEAL  (See INSTALLATION )
  10. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH  (See INSTALLATION )
  11. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH  (See INSTALLATION )
  12. INSTALL FRONT WIPER ARM HEAD CAP  (See INSTALLATION )
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.