Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Scion xB AutomaticFACTORY OEM SERVICE PROCEDURE
Circuit Protection Devices
CIRCUIT PROTECTION DEVICES LOCATION
| Component | Location |
|---|---|
| ABS R/B | Right rear of engine compartment. See Figure. |
| Diode H17 | At right side floor pan. See Figure. |
| Engine Room J/B | Left side of engine compartment. See Figure. |
| Engine Room R/B | On left side of engine compartment. See Figure. |
| Fusible Link Block | On left side of engine compartment. See Figure. |
| Instrument Panel J/B | Behind left side of dash. See Figure. |
| J/B No. 3 | Left side of dash. See Figure. |
| J/B No. 4 | Center of dash. See Figure. |
| Main Body ECU | Left side of dash. See Figure. |
| R/B No. 5 | Center of dash. See Figure. |
| R/B No. 6 | Center of dash. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.