2007 Scion tC Spec, AutomaticFACTORY OEM SERVICE PROCEDURE

Automatic Transaxle Assembly: Installation

  1. INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY 
    1. Using a vernier caliper, measure dimension "A" between the transaxle fitting part of the engine and the converter fitting part of the drive plate.
      Fig 1: Measuring Dimension A Between Transaxle Fitting Part Of Engine
      G04866265Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Set the key of the front oil pump drive gear to the top and put a mark on the housing.
      Fig 2: Setting Key Of Front Oil Pump Drive Gear
      G04866266Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Put a mark on the torque converter clutch so that its groove can be clearly indicated.
      Fig 3: Putting Mark On Torque Converter Clutch
      G04866267Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Match the 2 marks on the transaxle case and the torque converter clutch and fit the spline part of the input shaft to the spline part of the turbine runner.
      Fig 4: Identifying Match Marks On Transaxle Case And Torque Converter Clutch
      G04866268Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Rotating the torque converter clutch, fit the spline part of the stator shaft with the spline part of the stator.

      HINT:

      Rotate it about 180°.

      Fig 5: Fitting Spline Part Of Stator Shaft With Spline Part Of Stator
      G04866269Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Rotating the torque converter clutch, match the 2 marks on the case and the torque converter clutch again and fit the key of the oil pump drive gear into the key way of the torque converter clutch.
      NOTE: When rotating the torque converter clutch, do not push it with excessive force.
Chapter Navigation
Return to Chapter: Automatic Transaxle Assembly
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.