Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Scion tC Spec, AutomaticFACTORY OEM SERVICE PROCEDURE
General Maintenance
- INSPECT BRAKE LINES AND HOSES
HINT:
Work in a well-lighted area. Turn the front wheels fully to the right or left before beginning the inspection.
- Using a mirror, check the entire circumference and length of the brake lines and hoses for:
- Damage
- Wear
- Deformation
- Cracks
- Corrosion
- Leaks
- Bends
- Twists
- Check all the clamps for tightness and the connections for leakage.
- Check that the hoses and lines are not near sharp edges, moving parts or the exhaust system.
- Check that the lines are installed properly and pass through the center of the grommets.
- Using a mirror, check the entire circumference and length of the brake lines and hoses for:
- INSPECT BRAKE LININGS AND DRUMS
- Check the brake linings and drums. Also check the brake linings of parking brake.
- INSPECT FRONT BRAKE
- Check the front brake pads and discs (see INSPECTION ).
- INSPECT REAR BRAKE
- Check the rear brake pads and discs (see INSPECTION ).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.