Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
- CHECK MILÂ
- Check that MIL (Malfunction Indicator Lamp) lights up when turning the ignition switch to the ON position.
Standard:Â
MIL lights upÂ
NG: SYSTEM OKÂ
NG: GO TO NEXT STEPÂ
- Check that MIL (Malfunction Indicator Lamp) lights up when turning the ignition switch to the ON position.
- CHECK CONNECTION BETWEEN INTELLIGENT TESTER AND ECMÂ
- Connect the intelligent tester to the DLC3.
- Turn the ignition switch to the ON position and turn the intelligent tester on.
- Check the communication between the intelligent tester and ECM.
ResultÂ
RESULT REFERENCECondition Proceed to Communication Is possible A Communication Is not possible B
A: GO TO Â MIL CIRCUITÂ Â
B: GO TO NEXT STEPÂ
- INSPECT ECM (VC VOLTAGE)Â
- CHECK MIL (THROTTLE POSITION SENSOR)Â
- Disconnect the T1 throttle body connector.
- Turn the ignition switch to the ON position.
- Check the MIL.
ResultÂ
MIL RESULT REFERENCECondition Proceed to MIL illuminates A MIL does not illuminate B
A: REPLACE THROTTLE BODYÂ
B: GO TO NEXT STEPÂ
- CHECK MIL (CANISTER PUMP MODULE)Â
- Disconnect the T1 throttle body connector.
- Turn the ignition switch to the ON position.
- Check the MIL
ResultÂ
MIL RESULT REFERENCECondition Proceed to MIL Illuminates A MIL does not illuminate B
A: REPLACE CANISTERÂ
B: GO TO NEXT STEPÂ
- CHECK WIRE HARNESS (ECM - BODY GROUND)Â
- Disconnect the T1 throttle body connector.
- Disconnect the L1 canister pump module connector.
- Disconnect the E8 ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard resistanceÂ
WIRE HARNESS TESTER CONNECTION AND SPECIFIED CONDITIONTester Connection Specified Condition E8-18 (VC) - Body ground 10 kΩ or higher
NG: REPAIR OR REPLACE HARNESS OR CONNECTORÂ
OK: REPLACE ECMÂ
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
