Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
- CHECK THAT MIL IS ILLUMINATEDÂ
- Perform troubleshooting in accordance with the chart below.
ResultÂ
MIL IS ILLUMINATED RESULT REFERENCECondition Proceed to MIL remains Illuminated A MIL not illuminated B
B: Go to step   4Â
A: GO TO NEXT STEPÂ
- Perform troubleshooting in accordance with the chart below.
- CHECK WHETHER MIL TURNS OFFÂ
- Connect the intelligent tester to the DLC3.
- Turn the ignition switch to the ON position.
- Turn the tester on.
- Check whether any DTCs have been stored (See DTC CHECK / CLEARÂ ). Note them down if necessary.
- Clear the DTCs (See DTC CHECK / CLEARÂ ).
- Check if the MIL turns off.
OK:Â
MIL should turn off.Â
OK: REPAIR CIRCUIT INDICATED BY OUTPUT DTCÂ
NG: GO TO NEXT STEPÂ
- CHECK WIRE HARNESS (FOR SHORT)Â
- Disconnect the E5 ECM connector.
- Turn the ignition switch to the ON position.
- Check that the MIL is not illuminated.
OK:Â
MIL is not illuminatedÂ
OK: REPLACE ECMÂ
NG: CHECK AND REPAIR HARNESS AND CONNECTOR (COMBINATION METER - ECM)Â
- CHECK THAT MIL IS ILLUMINATEDÂ
- Check if the MIL is illuminated when the ignition switch is turned to the ON position.
OK:Â
MIL should be illuminated.Â
OK: SYSTEM OKÂ
NG: GO TO NEXT STEPÂ
- Check if the MIL is illuminated when the ignition switch is turned to the ON position.
- CHECK THAT ENGINE STARTSÂ
- Turn the ignition switch to the ON position.
- Start the engine.
ResultÂ
ENGINE STARTS RESULT REFERENCEResult Proceed to Engine starts A Engine does not start* B HINT:
*: The intelligent tester cannot communicate with the ECM.
B: GO TO Â VC OUTPUT CIRCUITÂ Â
A: GO TO NEXT STEPÂ
- INSPECT COMBINATION METER (MIL CIRCUIT)Â
- See the combination meter troubleshooting procedure (See HOW TO PROCEED WITH TROUBLESHOOTING ).
NG: REPAIR OR REPLACE BULB OR COMBINATION METER ASSEMBLYÂ
OK: CHECK AND REPAIR HARNESS AND CONNECTOR (COMBINATION METER - ECMÂ
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
