2007 Scion tC Base, StandardFACTORY OEM SERVICE PROCEDURE

On-Vehicle Inspection

  1. INSPECT IGNITION COIL ASSEMBLY AND SPARK TEST 
    NOTE: In this section, the terms "cold" and "hot" refer to the temperature of the coils. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).
    1. Check the DTCs.
      NOTE: If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC.
    2. Check that sparks occur.
      1. Remove the No. 1 engine cover.
      2. Remove the ignition coil.
      3. Disconnect the 4 fuel injector connectors.
        Fig 1: Locating Fuel Injector Connectors
        G04865923Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      4. Using a 16 mm spark plug wrench, remove the 4 spark plugs.

        Torque: 19 N*m (195 kgf*cm, 14 ft.*lbf) 

        Fig 2: Locating Spark Plug
        G04865924Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      5. Install each spark plug into an ignition coil, and then connect the ignition coil connectors.
      6. Ground the spark plugs.
      7. Check that a spark occurs at each spark plug while the engine is being cranked.
        NOTE:
        • Be sure to ground the spark plugs when checking.
        • Replace the ignition coil if a physical impact is felt while holding the spark plug.
        • Do not crank the engine for more than 2 seconds.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.