2007 Scion tC Base, StandardFACTORY OEM SERVICE PROCEDURE

Ignition Coil: Installation

  1. INSTALL IGNITION COIL ASSEMBLY 
    1. Install the 4 ignition coil with the 4 bolts.

      Torque: 9.0 N*m (90 kgf*cm, 80 in.*lbf) 

      Fig 1: Locating Ignition Coil With Bolts
      G04865931Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the 4 ignition coil connectors.
  2. INSTALL ENGINE COVER (See  INSTALLATION  ) 
  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  4. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.