2007 Scion tC Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Transmission Revolution Sensor: Installation

  1. INSTALL SPEED SENSOR (NC SENSOR) 
    1. Coat a new O-ring with ATF and install it to the sensor.
    2. Install the sensor with the bolt.

      Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf) 

    3. Connect the sensor connector.
      Fig 1: Locating Speed Sensor Bolt
      G04866128Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL SPEED SENSOR (NT SENSOR) 
    1. Coat a new O-ring with ATF and install it to the sensor.
    2. Install the sensor with the bolt.

      Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf) 

    3. Connect the sensor connector.
  3. INSTALL AIR CLEANER ASSEMBLY 

    Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

    4. Fig 2: Locating Speed Sensor Bolt
    G04866129Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL BATTERY CARRIER (See  INSTALLATION  ) 
  5. INSTALL BATTERY (See  INSTALLATION  )
  6. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.