Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSCION2007TC BASE, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEM (2AZ-FE)CAMSHAFT POSITION SENSORINSPECTION
2007 Scion tC Base, Automatic
Camshaft Position Sensor: Inspection
2007 Scion tC Base, AutomaticSECTION Inspection
- INSPECT CAMSHAFT POSITION SENSOR
- Measure the resistance of the sensor.
Standard resistance
CAMSHAFT POSITION SENSOR TESTER CONNECTION AND SPECIFIED CONDITIONTester Connection Specified Condition 1(G+) - 2(G-) 835 to 1,400 Ω at cold 1(G+) - 2(G-) 1,060 to 1,645 Ω at hot NOTE: Cold and Hot mean the temperature of the coils themselves. Cold is from -10 to 50°C (14 to 122°F) and Hot is from 50 to 100°C (122 to 212°F).If the result is not as specified, replace the camshaft position sensor.
- Measure the resistance of the sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.