Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSCION2007TC BASE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONCOMPUTER RELEARNENGINE CONTROL SYSTEM (2AZ-FE)IG2 RELAYON-VEHICLE INSPECTION

2007 Scion tC Base, Automatic

On-Vehicle Inspection

2007 Scion tC Base, AutomaticSECTION On-Vehicle Inspection

REMOVE IG2 RELAY (Marking: IG2)
1. Remove the engine room relay block cover.
2. Remove the IG2 relay from the engine room relay block.

INSPECT IG2 RELAY

Measure the EFI relay resistance.

Standard resistance

IG2 RELAY TESTER CONNECTION AND SPECIFIED CONDITION

Tester Connection	Specified Condition
3-5	10 kΩ or higher
3-5	Below 1 Ω (when battery voltage Is applied to terminals 1 and 2)

If the result is not as specified, replace the relay.

INSTALL IG2 RELAY

Fig 1: Identifying IG2 Relay Terminals
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.