SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSCION2007TC BASE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONCOMPUTER RELEARNENGINE CONTROL SYSTEM (2AZ-FE)CRANKSHAFT POSITION SENSORINSTALLATION
2007 Scion tC Base, Automatic

Crankshaft Position Sensor: Installation

2007 Scion tC Base, AutomaticSECTION Installation
  1. INSTALL CRANKSHAFT POSITION SENSOR 
    NOTE: Make sure that the O-ring is not cracked or jammed when installing.
    1. Apply a light coat of engine oil to the O-ring of the sensor.
      Fig 1: Identifying O-Ring Of Sensor
      G04869333Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the sensor with the bolt.

      Torque: 9.0 N*m (90 kgf*cm, 80 in.lbf) 

    3. Install the wire harness clamp.
    4. Install the connector clamp.
    5. Connect the sensor connector.
    6. Confirm that the wire harness of the sensor is secured to the wire harness clamp bracket through the back of the rib of the timing chain cover.
  2. INSTALL GENERATOR ASSEMBLY (See  INSTALLATION  ) 
  3. INSTALL FAN AND GENERATOR V BELT (See  REMOVAL  ) 
  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  5. CHECK FOR ENGINE OIL LEAKAGE 
  6. INSTALL FRONT FENDER APRON SEAL RH (See  INSTALLATION  ) 
  7. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.