Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSCION2007TC BASE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEENGINE CONTROL SYSTEM (2AZ-FE)CRANKSHAFT POSITION SENSORREMOVAL
2007 Scion tC Base, Automatic
Crankshaft Position Sensor: Removal
2007 Scion tC Base, AutomaticSECTION Removal
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- REMOVE FRONT FENDER APRON SEAL RH (See REMOVAL )
- REMOVE FAN AND GENERATOR V BELT (See REMOVAL )
- REMOVE GENERATOR ASSEMBLY (See REMOVAL )
- REMOVE CRANKSHAFT POSITION SENSOR
- Disconnect the sensor connector.
- Remove the connector clamp.
- Remove the wire harness from the wire harness clamp bracket.
- Remove the wire harness clamp.
- Remove the bolt and sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.