Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
System Outline
The current is applied at all times through the STOP fuse to TERMINAL 2 of the stop light SW.
When the ignition SW is turned to ON position, the current from the GAUGE fuse flows to TERMINAL 5 of the shift lock control ECU.
Shift Lock Mechanism
With the ignition SW at ON position, when a signal that the brake pedal is depressed (Stop light SW on) and a signal that the shift lever is put in P position (Continuity P SW) is input to the shift lock control SW, the shift lock control SW operates and the current flows from TERMINAL 5 of the shift lock control SW to TERMINAL SLS+ to the shift lock solenoid to TERMINAL SLS- of the shift lock control SW to TERMINAL 1 to GROUND. This causes the shift lock solenoid to turn on (Plate stopper disengages) and the shift lever can shift into position other than P position.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
