Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
System Outline
The current always flows to TERMINAL 1 of the door lock control relay through the D/L fuse.
- Manual Lock Operation
When the door lock control SW or door key lock and unlock SW are operated to LOCK position, a lock signal is input to TERMINAL 18 or 20 of the door lock control relay and causes the door lock control relay to function. The current flows from TERMINAL 1 of the door lock control relay to TERMINAL 2 to the door lock motors to TERMINALS 3 and 11 of the door lock control relay to TERMINAL 12 to GROUND and the door lock motors locks the door.
- Manual Unlock Operation
When the door lock control SW or door key lock and unlock SW are operated to UNLOCK position, an unlock signal is input to TERMINAL 19, 21 or 22 of the door lock control relay and causes the door lock control relay to function. The current flows from TERMINAL 1 of the door lock control relay to TERMINALS 3 and 11 to the door lock motors to TERMINAL 2 of the door lock control relay to TERMINAL 12 to GROUND and the door lock motors unlocks the door.
- Double Operation Unlock Operation
When the door key lock and unlock SW front LH is turned to the unlock side, only the driver's door is unlocked. By turning the door key lock and unlock SW front LH to the unlock side, a signal is input to TERMINAL 21 of the door lock control relay, and if the signal is input again within 3 seconds by turning the SW to the unlock side again, current flows from TERMINAL 11 of the door lock control relay to the door lock motors to TERMINAL 2 of the door lock control relay to TERMINAL 12 to GROUND, causing all the other doors are unlocked.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
