2006 Scion xB AutomaticFACTORY OEM SERVICE PROCEDURE

Torque Specifications

Camshaft timing oil control valve 

CAMSHAFT TIMING OIL CONTROL VALVE TORQUE SPECIFICATIONS

Part Tightened N*m kgf*cm ft.*lbf
Camshaft timing oil control valve at Cylinder head 7.5 76 66 in.*lbf

Camshaft position sensor 

CAMSHAFT POSITION SENSOR TORQUE SPECIFICATIONS

Part Tightened N*m kgf*cm ft.*lbf
Camshaft position sensor at Cylinder head 8.0 82 71 in.*lbf

Crankshaft position sensor 

CRANKSHAFT POSITION SENSOR TORQUE SPECIFICATIONS

Part Tightened N*m kgf*cm ft.*lbf
Crankshaft position sensor at Cylinder bock 7.5 76 66 in.*lbf

Engine coolant temperature sensor 

ENGINE COOLANT TEMPERATURE SENSOR TORQUE SPECIFICATIONS

Part Tightened N*m kgf*cm ft.*lbf
Engine coolant temperature sensor at Cylinder bock 20 204 15

Throttle body 

THROTTLE BODY TORQUE SPECIFICATIONS

Part Tightened N*m kgf*cm ft.*lbf
Throttle body at Cylinder bock 30 306 22
Transmission oil filter tube sub-assembly at Cylinder head 5.5 56 49 in.*lbf
Oil cooler tube at Transmission oil filter tube sub-assembly 5.5 56 49 in.*lbf
Accelerator control valve cable at Throttle body 13 133 10
Air cleaner assembly at Body 7.8 80 69 in.*lbf
Air cleaner inlet at Body 7.5 76 66 in.*lbf

Knock sensor 

KNOCK SENSOR TORQUE SPECIFICATIONS

Part Tightened N*m kgf*cm ft.*lbf
Knock sensor at Cylinder block 20 204 15

Idle air control valve 

IDLE AIR CONTROL VALVE TORQUE SPECIFICATIONS

Part Tightened N*m kgf*cm ft.*lbf
Idle air control valve at Throttle body 3.4 35 30 in.*lbf

Throttle position sensor 

THROTTLE POSITION SENSOR TORQUE SPECIFICATIONS

Part Tightened N*m kgf*cm ft.*lbf
Throttle position sensor at Throttle body 2.0 20 18 in.*lbf

ECM 

ECM TORQUE SPECIFICATIONS

Part Tightened N*m kgf*cm ft.*lbf
Idle air control valve at Throttle body 3.0 31 27 in.*lbf
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.