Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Scion xB AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
Brake actuator
BRAKE CONTROL TORQUE SPECIFICATIONS
| Part Tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Brake actuator assembly at Brake actuator bracket | 5.4 | 55 | 48 in.*lbf |
| Brake actuator assembly with bracket at Body | 19 | 194 | 14 |
| Brake actuator assembly at Brake tube (without SST) | 15 | 155 | 11 |
| Brake actuator assembly at Brake tube (with SST) | 14 | 143 | 10 |
Front speed sensor
FRONT SPEED SENSOR TORQUE SPECIFICATIONS
| Part Tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Front speed sensor | 8.0 | 82 | 71 in.*lbf |
| Front speed sensor wire harness clamp at Body | 8.0 | 82 | 71 in.*lbf |
| Front speed sensor wire harness clamp at Shock absorber | 29 | 300 | 22 |
| Wheel nut | 103 | 1, 050 | 76 |
Skid control sensor
SKID CONTROL SENSOR TORQUE SPECIFICATIONS
| Part Tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Rear axle hub and bearing assembly (skid control sensor) at Body | 61 | 622 | 45 |
| Wheel nut | 103 | 1, 050 | 76 |
Yaw rate sensor
YAW RATE SENSOR TORQUE SPECIFICATIONS
| Part Tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Yaw rate sensor at Body | 14 | 143 | 10 |
Steering sensor
STEERING SENSOR TORQUE SPECIFICATIONS
| Part Tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Steering pad assembly at Steering wheel assembly | 8.8 | 90 | 78 in.*lbf |
| Steering wheel assembly at Steering column shaft | 50 | 510 | 37 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
