Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
VC Output Circuit: Wiring Diagram
- CHECK MILÂ
- Check that MIL (Malfunction Indicator Lamp) lights up when turning the ignition switch ON.
Standard:Â
MIL lights upÂ
OK : SYSTEM OKÂ
NGÂ
- CHECK CONNECTION BETWEEN INTELLIGENT TESTER AND ECMÂ
- Connect the intelligent tester to the DLC3.
- Turn the ignition switch ON and turn the intelligent tester ON.
- Check the communication between the intelligent tester and ECM.
ResultÂ
RESULT CHARTCondition Proceed To Communication is possible A Communication is not possible B A : GO TO MIL CIRCUITÂ
B : Go to next stepÂ
- INSPECT ECM (VC VOLTAGE)Â
- Turn the ignition switch ON.
- Measure the voltage of the ECM connector.
ResultÂ
TESTER CONNECTION SPECIFIED CONDITION CHARTTester Connection Specified Condition E8-18 (VC) - E6-1(E1) Voltage is not 5 V NEXTÂ
- CHECK MIL (THROTTLE POSITION SENSOR)Â
- Disconnect the T1 throttle body connector.
- Turn the ignition switch ON.
- Check the MIL.
ResultÂ
RESULT CHARTCondition Proceed To MIL illuminates A MIL does not illuminate B A : REPLACE THROTTLE BODYÂ
B : Go to next stepÂ
- CHECK MIL (CANISTER PUMP MODULE)Â
- Disconnect the T1 throttle body connector.
- Turn the ignition switch ON.
- Check the MIL.
ResultÂ
RESULT CHARTCondition Proceed To MIL illuminates A MIL does not illuminate B A : REPLACE CANISTERÂ
B : Go to next stepÂ
- CHECK WIRE HARNESS (ECM - BODY GROUND)Â
- Disconnect the T1 throttle body connector.
- Disconnect the L1 canister pump module connector.
- Disconnect the E8 ECM connector.
- Measure the resistance of the wire harness side connector.
Standard resistanceÂ
TESTER CONNECTION SPECIFIED CONDITION CHARTTester Connection Specified Condition E8-18 (VC) - Body ground 10 kΩ or higher NG : REPAIR OR REPLACE HARNESS AND CONNECTORÂ
OK : REPLACE ECMÂ
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
