Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
How To Proceed With Troubleshooting
HINT:
*: Use the intelligent tester.
- VEHICLE BROUGHT TO WORKSHOPÂ
NEXT: Go To Next Step.Â
- CUSTOMER PROBLEM ANALYSISÂ
NEXT: Go To Next Step.Â
- CONNECT INTELLIGENT TESTER TO DLC3*Â
HINT:
If the display indicates a communication fault in the tester, inspect the DLC3.
NEXT: Go To Next Step.Â
- CHECK DTC AND FREEZE FRAME DATA*Â
HINT:
Record or print DTCs and freeze frame data, if necessary.
- CLEAR DTC AND FREEZE FRAME DATA*Â
NEXT: Go To Next Step.Â
- CONDUCT VISUAL INSPECTIONÂ
NEXT: Go To Next Step.Â
- SET CHECK MODE DIAGNOSIS*Â
NEXT: Go To Next Step.Â
- CONFIRM PROBLEM SYMPTOMSÂ
HINT:
If the engine does not start, first perform "CHECK DTC" procedures and "CONDUCT BASIC INSPECTION" procedures below.
CONFIRM PROBLEM SYMPTOMSResult Proceed to Malfunction does not occur A Malfunction occurs B B : GO TO STEP Â Â 10Â
A : Go to next stepÂ
- SIMULATE SYMPTOMSÂ
NEXT: Go To Next Step.Â
- CHECK DTC*Â DTC CHART
Result Proceed to Malfunction code A No code B B : GO TO STEP Â Â 12Â
A : Go to next stepÂ
- REFER TO DTC CHARTÂ
NEXT: Go To Next Step.Â
GO TO STEP Â Â 14Â
- CONDUCT BASIC INSPECTIONÂ CONDUCT BASIC INSPECTION
Result Proceed to Malfunctioning parts not confirmed A Malfunctioning parts confirmed B B : GO TO STEP Â Â 17Â
A : Go to next stepÂ
- REFER TO Â PROBLEM SYMPTOMS TABLEÂ Â DIAGNOSIS PROCEDURE
Result Proceed to Malfunctioning circuit confirmed A Malfunctioning parts confirmed B B : GO TO STEP Â Â 17Â
A : Go to next stepÂ
- CHECK ECM POWER SOURCE CIRCUITÂ
NEXT: Go To Next Step.Â
- CONDUCT CIRCUIT INSPECTIONÂ CONDUCT CIRCUIT INSPECTION CHART
Result Proceed to Malfunction not confirmed A Malfunction confirmed B B : GO TO STEP Â Â 18Â
A : Go to next stepÂ
- CHECK FOR INTERMITTENT PROBLEMSÂ
NEXT: Go To Next Step.Â
GO TO STEP Â Â 18Â
- CONDUCT PARTS INSPECTIONÂ
NEXT: Go To Next Step.Â
- IDENTIFY PROBLEMÂ
NEXT: Go To Next Step.Â
- ADJUST AND/OR REPAIRÂ
NEXT: Go To Next Step.Â
- CONDUCT CONFIRMATION TESTÂ
NEXT: Go To Next Step.Â
ENDÂ
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
