Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Scion xB AutomaticFACTORY OEM SERVICE PROCEDURE
Automatic Transmission DTCS
AUTOMATIC TRANSMISSION DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| DTC P0705 | Transmission Range Sensor Circuit Malfunction (PRNDL Input) |
| DTC P0710, P0712, P0713 | Transmission Fluid Temperature Sensor "A" Circuit, Low Input & High Input |
| DTC P0711 | Transmission Fluid Temperature Sensor "A" Performance |
| DTC P0717 | Turbine Speed Sensor Circuit No Signal |
| DTC P0724 | Brake Switch "B" Circuit High |
| DTC P0741 | Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve SL) |
| DTC P0751 | Shift Solenoid "A" Performance (Shift Solenoid Valve S1) |
| DTC P0756 | Shift Solenoid "B" Performance (Shift Solenoid Valve S2) |
| DTC P0787, P0788 | Shift/Timing Solenoid Low/High (Shift Solenoid Valve ST) |
| DTC P0973, P0974 | Shift Solenoid "A" Control Circuit Low/High (Shift Solenoid Valve S1) |
| DTC P0976, P0977 | Shift Solenoid "B" Control Circuit Low/High (Shift Solenoid Valve S2) |
| DTC P2716 | Pressure Control Solenoid "D" Electrical (Shift Solenoid SLT) |
| DTC P2769, P2770 | Torque Converter Clutch Solenoid Circuit Low/High (Shift Solenoid Valve SL) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.