Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Scion xB AutomaticFACTORY OEM SERVICE PROCEDURE
Camshaft Position Sensor: Replacement
- REMOVE AIR CLEANER ASSY (See REMOVAL & INSTALLATION AND DISASSEMBLY & REASSEMBLY )
- REMOVE CAMSHAFT POSITION SENSOR
- Disconnect the camshaft position sensor connector.
- Remove the bolt and camshaft position sensor.
- INSTALL CAMSHAFT POSITION SENSOR
- Apply a light coat of engine oil to the O-ring on the camshaft position sensor.
- Install the camshaft position sensor with the bolt.
Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
- Connect the camshaft position sensor connector.
- INSTALL AIR CLEANER ASSY (See REMOVAL & INSTALLATION AND DISASSEMBLY & REASSEMBLY )
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.