Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Scion xA StandardFACTORY OEM SERVICE PROCEDURE
Service Data
SERVICE DATA
| Fuel pressure | 304 to 343 kPa (3.1 to 3.5 kgf/cm2 , 44 to 50 psi) | |
|---|---|---|
| Fuel injector | - | |
| Resistance | at 20° C (68° F) | 13.4 to 14.2 Ω |
| Injection volume | 47 to 58 cm2 (2.9 to 3.5 cu in.) per 15 seconds | |
| Difference between each cylinder | 11 cm3 (0.6 cu in.) or less | |
| Fuel leakage | 1 drop or less per 12 minutes | |
| Fuel pump | - | |
| Resistance | at 20°C (68°F) | 0.2 to 3.0 Ω |
| Compression spring | - | |
| Free length | Minimum | 40.5 mm (1.594 in.) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.