Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Basic Inspection
When a malfunction is not confirmed by the DTC check, troubleshooting should be carried out in all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following flow-chart, the location of the problem can be found quickly and efficiently. Therefore, using this check is essential when engine troubleshooting.
- CHECK BATTERY VOLTAGEÂ NOTE: Carry out this check with the engine stopped and ignition switch OFF.VOLTAGE SPECIFICATIONS
Result Proceed To 11 V or more OK Below 11 V NG - NG: CHARGE OR REPLACE BATTERYÂ
- OK: GO TO NEXT STEPÂ
- CHECK WHETHER ENGINE WILL CRANKÂ
- NG: PROCEED TO Â PROBLEM SYMPTOMS TABLEÂ Â
- OK: GO TO NEXT STEPÂ
- CHECK WHETHER ENGINE STARTSÂ
- NG: GO TO STEP Â Â 6Â
- OK: GO TO NEXT STEPÂ
- CHECK AIR FILTERÂ
- Visually check that the air filter is not excessively contaminated with dirt or oil.
- NG: REPLACE AIR FILTERÂ
- OK: GO TO NEXT STEPÂ
- CHECK IDLING SPEED (See  INSPECTIONÂ
)Â
- NG : PROCEED TO Â INSPECTIONÂ AND CONTINUE TROUBLESHOOTINGÂ
- OK : PROCEED TO Â PROBLEM SYMPTOMS TABLEÂ Â
- CHECK FUEL PRESSURE (See  ON-VEHICLE INSPECTIONÂ
)Â
- NG : PROCEED TO Â ON-VEHICLE INSPECTIONÂ AND CONTINUE TROUBLESHOOTINGÂ
- OK : GO TO NEXT STEPÂ
- CHECK FOR SPARK (See  ON-VEHICLE INSPECTIONÂ
)Â
- NG : PROCEED TO Â ON-VEHICLE INSPECTIONÂ AND CONTINUE TROUBLESHOOTINGÂ
- OK : PROCEED TO Â PROBLEM SYMPTOMS TABLEÂ Â
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
