Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Scion xA AutomaticFACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Code Table
If a DTC is displayed during the DTC check, check the circuit listed in the table below and proceed to the page given.
HINT:
- *1: "X" ... MIL (Malfunction Indicator Lamp) light up
- *2: ""x"" mark means ECM memorizes the malfunction code if the ECM detects the DTC detection condition.
- This DTC may be output when the clutch, brake and gear components etc. inside the automatic transaxle are damaged.
DIAGNOSTIC TROUBLESHOOTING CODE
| DTC No. (See Reference) | Detection Item | Trouble Area | MIL *1 | Memory *2 |
|---|---|---|---|---|
| DTC P0500 VEHICLE SPEED SENSOR "A" | Vehicle Speed Sensor "A" |
|
"X" | O |
| P0705 (DTC P0705 TRANSMISSION RANGE SENSOR CIRCUIT MALFUNCTION (PRNDL INPUT) ) | Transmission Range Sensor Circuit Malfunction (PRNDL Input) |
|
"X" | O |
| P0710 | Transmission Fluid Temperature Sensor "A" Circuit |
|
"X" | O |
| P0711 | Transmission Fluid Temperature Sensor "A" Performance |
|
"X" | O |
| P0712 | Transmission Fluid Temperature Sensor "A" Circuit Low Input |
|
"X" | O |
| P0713 | Transmission Fluid Temperature Sensor "A" Circuit High Input |
|
"X" | O |
| P0717 | Turbine Speed Sensor Circuit No Signal |
|
"X" | O |
| P0724 ( DTC P0724 BRAKE SWITCH "B" CIRCUIT HIGH ) | Brake Switch "B" Circuit High |
|
"X" | O |
| P0741 | Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve SL) |
|
"X" | O |
| P0751 | Shift Solenoid "A" Performance (Shift Solenoid Valve S1) |
|
"X" | O |
| P0756 | Shift Solenoid "B" Performance (Shift Solenoid Valve S2) |
|
"X" | O |
| P0787 | Shift/Timing Solenoid Low (Shift Solenoid Valve ST) |
|
"X" | O |
| P0788 | Shift/Timing Solenoid High (Shift Solenoid Valve ST) |
|
"X" | O |
| P0973 | Shift Solenoid "A" Control Circuit Low (Shift Solenoid Valve S1) |
|
"X" | O |
| P0974 | Shift Solenoid "A" Control Circuit High (Shift Solenoid Valve S1) |
|
"X" | O |
| P0976 | Shift Solenoid "B" Control Circuit Low (Shift Solenoid Valve S2) |
|
"X" | O |
| P0977 | Shift Solenoid "B" Control Circuit High (Shift Solenoid Valve S2) |
|
"X" | O |
| P2716 | Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT) |
|
"X" | O |
| P2769 | Torque Converter Clutch Solenoid Circuit Low (Shift Solenoid Valve SL) |
|
"X" | O |
| P2770 | Torque Converter Clutch Solenoid Circuit High (Shift Solenoid Valve SL) |
|
"X" | O |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.