2005 Scion xA AutomaticFACTORY OEM SERVICE PROCEDURE

Service Data

SERVICE DATA

Idle speed control valve assy -
Movement Ignition switch ON Half open --> fully close --> fully open --> half open
Air flow meter -
Resistance THA-E2 -
- at -20°C (-4°F) 13.6 to 18.4 kΩ
- at 20°C (68°F) 2.21 to 2.69 kΩ
- at 60°C (140°F) 0.49 to 0.67 kΩ
Camshaft oil control valve assy -
Resistance at 20°C (68°F) 6.9 to 7.9 Ω
Throttle position sensor -
Resistance VC-E2 2.5 to 6.0 kΩ
Engine coolant temperature sensor -
Resistance Approx. 20°C (68°F) 2.29 to 2.60 kΩ
- Approx. 80°C (176°F) 0.301 to 0.327 kΩ
EFI relay -
Specified condition 3 - 5 10 kΩ or higher
- Below 1 Ω (Apply battery voltage to terminal 1 and 2)
Circuit opening relay -
Specified condition 3 - 5 10 kΩ or higher
- Below 1 Ω (Apply battery voltage to terminal 1 and 2)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.