2005 Scion xA AutomaticFACTORY OEM SERVICE PROCEDURE

General Information: Notes

A large number of ECU controlled systems are used in the SCION xA. In general, ECU controlled systems are considered to be very intricate, requiring a high level of technical knowledge to troubleshoot. However, most problem checking procedures only involve inspecting the ECU controlled system's circuits one by one. An adequate understanding of the system and a basic knowledge of electricity is enough to perform effective troubleshooting, accurate diagnoses and necessary repairs. Detailed information and troubleshooting procedures on major ECU controlled systems in this vehicle are outlined below:

SYSTEM SPECIFICATION

System Reference
SFI System DEFINITION OF TERMS
ABS with EBD System PRECAUTION
ABS with EBD & BA & TRAC & VSC System PRECAUTION
Electronically Controlled Automatic Transmission [ECT] PRECAUTION
Supplemental Restraint System PRECAUTION
Combination Meter HOW TO PROCEED WITH TROUBLESHOOTING
Power Door Lock Control System SYSTEM DESCRIPTION
CAN Communication System PRECAUTION
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.