Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Scion xB StandardFACTORY OEM SERVICE PROCEDURE
Service Data
SERVICE DATA SPECIFICATIONS
| ECM Voltage | ||
| VC-E2 | 4.5 to 5.5 V | |
| PTNK-E2 | 3.0 to 3.6 V | |
| VSV For Canister Closed Valve Resistance | ||
| at 20°C (68°F) | 25 to 30 ohm | |
| at 100°C (212°F) | 32 to 40 ohm | |
| Duty Vacuum Switching Valve Resistance At 20°C (68°F) | 30 to 34 ohm | |
| Heated Oxygen Sensor Resistance | ||
| HT (1) - +B (2) | Continuity | |
| HT (1) - E2 (4) | No Continuity | |
| Heated Oxygen No. 2 Sensor Resistance | ||
| HT (1) - +B (2) | Continuity | |
| HT (1) - E2 (4) | No Continuity | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.