Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Scion xA StandardFACTORY OEM SERVICE PROCEDURE
Problem Symptoms Table
PROBLEM SYMPTOMS
| Symptom/Suspected Area | See | |
|---|---|---|
| Driver Side Seat Belt Warning Lamp Does Not Light Up | ||
| 1. GAUGE Fuse | ..... | |
| 2. Combination Meter | OVERHAUL | |
| 3. Airbag Sensor Assembly Center | AIR BAG CENTER SENSOR | |
| 4. Front Seat Inner Belt Assy LH | INSPECTION | |
| 5. Wire Harness | ..... | |
| Driver Side Seat Belt Warning Lamp Does Not Turn Off | ||
| 1. Combination Meter | OVERHAUL | |
| 2. Airbag Sensor Assembly Center | AIR BAG CENTER SENSOR | |
| 3. Front Seat Inner Belt Assy LH | INSPECTION | |
| 4. Wire Harness | ..... | |
| Passenger Side Seat Belt Warning Lamp Does Not Light Up | ||
| 1. GAUGE Fuse | ..... | |
| 2. Front Seat Cushion Pad RH | INSPECTION | |
| 3. Instrument Panel Garnish Sub-Assy | COMPONENTS | |
| 4. Front Seat Inner Belt Assy RH | INSPECTION | |
| 5. Combination Meter | OVERHAUL | |
| 6. Wire Harness | ..... | |
| Passenger Side Seat Belt Warning Lamp Does Not Turn Off | ||
| 1. Instrument Panel Garnish Sub-Assy | COMPONENTS | |
| 2. Front Seat Cushion Pad RH | INSPECTION | |
| 3. Front Seat Inner Belt Assy RH | INSPECTION | |
| 4. Combination Meter | OVERHAUL | |
| 5. Wire Harness | ..... | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.