Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2004 Scion xA AutomaticFACTORY OEM SERVICE PROCEDURE

Check Door Lock and Unlock Switch

WARNING: This page is about a different car, the 2003 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.

CHECK DOOR LOCK AND UNLOCK SWITCH
With CONSULT-II

See "DOOR LK SW-LK and UN" in DATA MONITOR mode with CONSULT-II.
- When door lock and unlock switch is turned to lock:
  1. DOOK LK SW-LK : OFF --> ON
- When lock and unlock switch is turned to unlock:
  1. DOOK LK SW-UN : OFF --> ON
  Fig 1: Display Data Monitor Mode With Consult-II
  Courtesy of NISSAN MOTOR CO., U.S.A.
Without CONSULT-II

Check door lock and unlock switch operation is "SWITCH MONITOR" mode. Refer to "SWITCH MONITOR ".

OK or NG

OK >> Door lock and unlock switch is OK.

NG >> Replace door lock and unlock switch.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.