WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Start from step 10, if it is possible to confirm that the fuel cannot be drained by 30 l (7-7/8 US gal, 6-5/8 Imp gal) in advance.

Prepare a fuel container and a spare hose.
Release fuel pressure from fuel line, refer to "FUEL PRESSURE RELEASE ".
Remove the fuel feed hose on the fuel level sensor unit.
Connect a spare fuel hose where the fuel feed hose was removed.
Turn ignition switch OFF and wait at least 10 seconds then turn ON.
Select "FUEL LEVEL SE" in "DATA MONITOR" mode with CONSULT-II.

Fig 1: CONSULT-II Data Monitor Display
Courtesy of NISSAN MOTOR CO., U.S.A.
Check "FUEL LEVEL SE" output voltage and note it.
Select "FUEL PUMP" in "ACTIVE TEST" mode with CONSULT-II.
Touch "ON" and drain fuel approximately 30 l (7-7/8 US gal, 6-5/8 Imp gal) and stop it.
Check "FUEL LEVEL SE" output voltage and note it.
Fill fuel into the fuel tank for 30 l (7-7/8 US gal, 6-5/8 Imp gal).
Check "FUEL LEVEL SE" output voltage and note it.
Confirm whether the voltage changes more than 0.03V during step 7 to 10 and 10 to 12.
If NG, go to "DIAGNOSTIC PROCEDURE ".

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

With Consult-II

Use the Manual With the Right Hardware

When to See a Mechanic